Air OPUS
®
BRAKE SET UP
About your Brakes
The Air OPUS
®
is fitted with electric trailer
brakes. You need an electric brake controller
fitted to your car in order to tow the
Air OPUS
®
and operate the electric
brakes safely. Before departing, place car in
drive and check that the Air OPUS
®
brakes are
on. Refer to brake controller user manual for
correct adjustment.
BREAK-AWAY SWITCH
Your camper comes with a break-away
switch. This is a safety device which will
apply the trailer brakes if it becomes
disconnected from the tow vehicle
MAINTENANCE
As part of the annual service check you
should have completed by an accredited
industry service agent, the brakes should be
checked and maintained.
IMPORTANT
The break-away switch is not a security
device! When cable is pulled, switch
will drain power from batteries
www.opuscamper.us
9
T ENT INFLA
TION TECHNOLOGY
Initial Steps
STEP 1
- Once you have positioned & leveled your
Air OPUS
®
on flat ground (leveling wedges may be
required - not supplied), engage the handbrake &
disconnect hitch, wiring & chains from tow vehicle.
STEP 2
- Raise or lower the jockey wheel to level
your Air OPUS
®
lengthways.
STEP 3
- Using the leg winder supplied, gently
lower corner steady legs until each touches the
ground with enough pressure to stop any rocking.
STEP 4
- If you have a drop down spare wheel set
up, please adhere to these safety requirements.
Unclip the spare wheel carrier and lower it down
gently to the horizontal position, taking care to
support the weight of the spare wheel carrier so
that it does not swing free and fall.
SETTING UP YOUR Air OPUS
®
CAMPER
IMPORTANT
Corner support legs are only to
support the Air OPUS
®
NOT to be
used to level or lift.
STEP 5
- If roof rack is fitted,
remove D Clips and unlatch the
2 retaining clips. Once rack is free
push up until the gas struts take
the weight. From the other side
of the camper pull roof rack
into vertical position and secure
upright with D clips through
mounting point.
www.opuscamper.us
10
T ENT INFLA
TION TECHNOLOGY