6. Secure the NIND with four self tapping 3/4” screws being careful not to over-
tighten.
7. Secure the power adapter with included self tapping 1/2” screws.
8. Adhere the two included warning labels in close proximity to the NIND device.
Plug the included power adapter into the nano Induct. Connect the power adapter
to a 110 or 240 VAC electrical outlet. The unit will start, with the green lights and
blue lights illuminating.
It’s designed for continuous operation. For maximum effectiveness, operate the
unit 24 hours a day, 7 days a week.
Optional 24 VAC Internal HVAC Power Source Wiring
When wiring direct to 24V we strongly recommend installing a separate 40 VA
transformer to ensure optimal performance.
SAFETY CONSIDERATIONS
Read and follow manufacturer instructions carefully. Follow all local electrical codes
during installation. All wiring, must conform to local and national electrical codes.
Improper wiring, or installation may damage unit and/or cause serious injury.
WARNING
Before beginning any modification, be certain that the main line electrical discon-
nect switch is in the OFF position. Electric shock could result. Tag disconnect
switch with suitable warning labels.
Installation and servicing of air-conditioning equipment can be hazardous due to
system pressure and electrical components. Only trained and qualified service
personnel should install, repair, or service air-conditioning equipment. Air Oasis
and its affiliates are not responsible for any damage to the HVAC system, NIND or
injury to yourself or others if you elect to install the NIND without utilizing qualified
technicians.
WARNING
The NIND is designed to operate at 24 VAC. Damage or physical injury could result
if wired to higher voltages.
1. Wire electrical power plug to the 24 VAC internal power source. Before wiring
the NIND to the power source, check with a voltmeter that the source does not
exceed 30 VAC.
2. Insert the power plug into the port on the NIND. If it is necessary to pass the
cord through a hole in the wall of the air handler or through an access door,
a rubber grommet should be inserted in the hole or electrical tape should be
wrapped around the cord at the point of entry for protection.
24 VAC
Power
Source
Solid Black (-) Outside
White Stripe (+) Inside
Note: If one terminal of power source
is grounded, hook the black wire to
this terminal.
Initial Start Up
7
