4. Web Management
AirLive SNMP-GSH2004L User’s Manual
22
Enable Jumbo Frames:
This function support jumbo frames of up to 9600 bytes, Just tick the check box ( ) to
enable it.
Default: disable
Perfect Reach/Power Saving Mode:
This function supports Power Saving and perfect Reach, Just select with the Full/ Link-up/
Link-down/ Disable
Default: disable
Link:
Show link status of this port.
Mode:
Set the speed and duplex of the port. If the media is 1Gbps fiber, there are three modes to
choose: Auto Speed, 1000 Full and Disable. If the media is TP, the Speed/Duplex is
comprised of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full
duplex and half duplex.
In Auto Speed mode, no default value. In Forced mode, default value depends on your
setting.
Flow Control:
You can Just tick the check box ( ) to enable flow control. If flow control is set Enable, both
parties can send PAUSE frame to the transmitting device(s) if the receiving port is too busy
to handle. When it is set Disable, there will be no flow control in the port. It drops the packet
if too much to handle.
Default: Disable
4.4.3 VLAN Mode Configuration
Web Smart Switch supports Port-based VLAN and Tag-based VLAN (802.1q). Its VLAN
mode supports 10 active VLANs and the available VLAN ID range is from 1~4094. VLAN
configuration is used to divide a LAN into smaller ones. With proper configuration, you can
gain not only improved security and increased performance, but also save a lot of VLAN
management effort.
The VLAN Mode Selection function includes two modes: Port-based, Tag-based.