10
3.5 INSTALLING WIRE SPOOL AND
ADJUSTING HUB TENSION
1
. Install the wire spool (See figure 2)
2
. To increase tension, adjust the 11/16” nut in a
clockwise direction.
3
. To decrease tension, adjust the 11/16” nut in a
counter clockwise direction.
3.6 INSTALLING THE WIRE INTO THE
WELDING GUN
1
. Open the pressure assembly on the wire feeder.
2
. Push wire through guide into gun.
3
. Close and tighten pressure assembly.
4.
Remove gun nozzle and contact tip.
5
. Press the gun trigger until wire comes out of
the welding gun.
Typical Weld Parameter Settings: M 132
Fig. 2
Typical Weld Parameter Settings: M 172
6
. Reinstall contact tip and nozzle.
7
. Feed wire by pressing the gun trigger to check
drive roll pressure.
8
. Tighten pressure assembly knob enough to pre-
vent slippage.
9
. Cut off wire and begin welding.
Summary of Contents for M 132
