Air Lift RideControl 59570, Installation Manual

Page: 7 / 24

5
MN-962
INSTALLING THE UPPER BRACKETS
1. Jack the vehicle up and support the axle with safety stands. Remove the rear wheels
(fig. 2).
2. Unbolt and remove the jounce bumpers (these will be reinstalled later) (fig. 3).
3. Set the frame U-bolts (D) around the frame from the inside-out on both sides of the
vehicle—ahead of and behind where the jounce bumper is mounted. Figure 6 shows
both U-bolts installed between the brake lines and wiring. Repeat U-bolt installation
for the right side (passenger side).
DO NOT PINCH THE BRAKE LINES AND WIRING ON THE INSIDE OF THE LEFT
(DRIVER SIDE FRAME). U-BOLTS MUST BE BETWEEN THESE COMPONENTS AND
THE FRAME (FIGS. 4, 5, AND 6).
Installing the RideControl System
fig. 2
fig. 3
fig. 4
Remove
the jounce
bumpers.
These will be
reinstalled
later.
Figure 4 shows
U-bolt (D) being
installed on the
inside of the left
(driver-side) frame
section on the
back side of the
jounce bumper
mounting location.
D
CAUTION
RideControl