Air Lift 1000
MN-34
3
B. Hardware and Tools Lists
Item Part #
Description.....................................Qty
A
48171
Air spring .................................................... 2
B 09453
Protector .................................................... 1
C 09567
Protector .................................................... 1
D
20937
Air line assembly ........................................ 1
E
10466
Zip ties ....................................................... 4
F
21230
Valve cap ................................................... 2
G
21233
5/16” Hex nut ............................................. 4
H
21234
Rubber washer ........................................... 2
I
18411
Star washer ................................................ 2
J
18405
5/16” Flat washer ....................................... 2
K 21236
Tee ............................................................. 1
L 21455
Valve .......................................................... 2
M
10638
Uni clamps ................................................. 6
HARDWARE LIST
TOOLS LIST
Description ...................................................... Qty
Hoist or floor jacks
.......................................................... 1
Safety stands .................................................................. 2
Safety glasses ................................................................ 1
Air compressor or compressed air source ...................... 1
Spray bottle with dish soap/water solution ..................... 1
C.
Installing the Air Lift 1000 System
GETTING STARTED
1. Jack up the rear of the vehicle or raise on a hoist. Support the frame with safety
stands.
2. Mark the location of the spring/upper spring mount with a marker so that the spring
can be reinstalled and indexed properly.
3. Remove the shock absorbers from the lower shock mounts on the axle. Lower the
axle or raise the body of the vehicle until the springs can be removed.
OBSERVE TENSION ON BRAKE LINE. DO NOT STRAIN. IF NECESSARY,
TEMPORARILY REMOVE ANY MOUNTING BRACKETS OR CLIPS TO CREATE MORE
SLACK.
CAUTION
4. Remove lower shock mounting nuts and remove bottom of shocks from the control
arm. Leave shocks attached at the top on both right and left side.
5. Remove coil spring on left side by lowering the axle (Fig. C.1)
fig. C.1
