Air Lift 1000
MARKING HOLE FOR AIR LINE
1. Place air cylinder into coil spring with the air stem facing down (Fig. C.2)
2. Place coil spring and air cylinder assembly on the control arm lower seat.
3. Mark the cylinder air stem location where it comes in contact with the control arm.
4. Remove coil spring and air spring assembly.
5. Center punch and drill 1/4” diameter pilot hole then drill 3/8” diameter final hole to
allow attachment of the air line to the air cylinder (Fig. C.3).
fig. C.2
fig. C.3
Control
arm
4
