*Operation Instruction
First Operation, put unit under the room temperature for half of an hour before running
(Especially when the outdoor temperature is lower than 5
℃)
.
It is recommended to use the unit under temperature of 5-40
℃
, relative humidity less than 80
％
RH.
Use clear water not over 4
0℃
.
Check the water basin, make sure it is clear.
Operation steps:
1.
Take the water tank (3) out of the base (7), revolve the tank-cap by the directions of
LOOSEN and FASTEN (5), and fill the water tank (3) with clear water. Close the tank-cap
(5), and put the water tank (3) onto the base (7) carefully.
2.
Put the Nozzle (1) into the socket on top of the water tank (3).
3.
Connect the power cord (9), switch on the unit (8) (NEVER RUN THE UNIT WHEN
THERE IS NO WATER IN WATER BASIN), the LED display will on for 2 seconds then be
off. The unit stands by.
4.
ON/OFF: It takes charge the electric supply of the whole unit. When press ON, the display is
on, the machine operates with the lowest mist output, at the same time the fan motor works.
When it is OFF, all the functions are invalid, and the display is off.
5.
DELAY START: When the unit stands by, press this button. The preset time can be chosen
from 1 hour to 24 hours. The preset time will be counted down to work with the highest mist
output. At the same time, Ionizer works, the humidity level is 99RH%.
6.
MIST: 4 levels from Low, Middle, Senior to High for different mist output. And the
