TROUBLESHOOTING GUIDE
PROBLEM
Jet will not start or
has low power.
Jet will not turn.
Jet is flying too low.
Jet is flying too high.
Motors don’t stop when
Controller is turned OFF.
CAUSE
1. Jet not charged.
2. Battery power is drained.
3. Jet was not set to OFF during
charging.
4. Controller/Charger was not set to
“Charger ON”.
1. Control is not ON.
2. Controller antenna is not extended.
3. It’s a windy day or you’re flying by a
vent/fan.
1. Needs more power.
2. The six AA batteries in the
Controller/Charger are drained.
1. Need to decrease power.
1. Set to full throttle.
SOLUTION
1. Charge jet for a complete charge cycle.
2. Replace the Controller/Charger batteries after 20 flights.
3. The jet won’t accept a charge in the ON position. Always set to
OFF before charging.
4. The Controller/Charger will NOT charge in the Controller OFF
position. Always set the Controller/Charger to ON before
attempting to charge.
1. Set Controller to Controller ON.
2. Fully extend Controller antenna before flying.
3. Do not fly in winds. Windy conditions will limit and prevent
your ability to control the jet.
1. Push the Throttle UP.
2. Install new batteries.
1. Pull the Toggle DOWN.
1. Turn Controller ON, reduce throttle to 0 and turn
Controller OFF.
4
NOTE:
If normal function of the product is disturbed or interrupted, strong electro-magnetic interference may be causing the issue. To
reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and
try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
IMPORTANT BATTERY INFORMATION
• Requires 6 x 1.5-V AA alkaline batteries (not included).
• Batteries are small objects.
• Replacement of batteries must be done by adults.
• Follow the polarity (+/-) diagram in the battery compartment.
• Promptly remove dead batteries from the toy.
• Dispose of used batteries properly.
• Remove batteries for prolonged storage.
• DO NOT incinerate used batteries.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• DO NOT mix old and new batteries or types of batteries
(i.e. alkaline/standard).
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• DO NOT short-circuit the supply terminals.
Your Thunder Strike™ is equipped with a
Lithium Polymer battery.
SPECIAL LiPO BATTERY INSTRUCTIONS:
• Never charge battery unattended.
• Charge battery in isolated area. Keep away from flammable materials.
• Do not expose to direct sunlight.
• There is a risk of the batteries exploding, overheating, or igniting.
Do not disassemble, modify heat, or short circuit the batteries.
Do not place them in fires or leave them in hot places.
• Do not drop or subject to strong impacts.
• Do not allow the batteries to get wet.
• Only charge the batteries with the specified Spin Master™ battery
charger.
• Only use the batteries in the device specified by Spin Master™.
• Carefully read the instruction guide, and use the batteries correctly.
• In the unlikely event of leakage or explosion use sand or a chemical
fire extinguisher for the battery.
• Batteries must be recycled or disposed of properly.
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation.
This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference to radio communications. Because this toy generates, uses, and can
radiate radio frequency energy, there can be no guarantee that interference will not occur. If this toy does cause interference to radio or television
reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be
useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an
experienced TV-radio technician for help.
NOTE:
Changes, adjustments or modifications to this unit, including but not limited to, replacement of any
transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly
approved by Spin Master Ltd. or they could void the user’s authority to operate the equipment.
TM
Spin Master Ltd., 450 Front Street West, Toronto,
ON M5V 1B6 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited. Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
®, TM and © 2009 Spin Master Ltd. All rights reserved. This product conforms to safety require-
ments of ASTM F963 & CHPA. • Please retain this information for future reference.
• Please remove all packaging materials before giving to children. • An adult should
periodically check this toy to ensure no damage or hazards exist, if so, remove from
use. • Children should be supervised during play. • Keep addresses and phone
numbers for future reference. • The item inside this package may vary from
the photographs and/or illustrations. Patent Pending. MADE IN CHINA.
20030163 NTL English REV 0
T44396_0001_20030163_NTL_IS_R1
This Category II radio communication device complies with Industry Canada Standard RSS-310.
Carrier frequency: 27.145MHz
Field strength: 61.0dBuV/m at 3m.
