7. System Configuration
air
avionics
P/N: AT-1-(00000)
ADS-B 1090-in, Flarm 868/915 MHz in/out
RTCA DO-160G:
D1ZBAB[UFF1]XXXXXXZBBBAC[TT]M[A2XXX]XXAX
9-32 V DC
*AT1-00003*
Figure 7.1.: AT-1 serial number sticker
Opening the AT-1 Configuration Webpage
1. Open a web browser in your personal device.
2. Enter the following address into the address bar of the browser and hit enter:
http://192.168.1.1
7.2 Simple, Advanced, and Expert Configuration Mode
As the AT-1 factory defaults already cover most of the requirements for normal installations,
only few changes have to be made. Therefore, a simple configuration mode is available
that covers the basic configuration parameters required for normal installations.
We strongly recommend to only use the simple configuration mode, unless you
are a very experienced installer and know exactly what you are doing. Setup
parameters in the advanced and expert configuration modes will negatively affect
device performance if not set correctly.
In the advanced configuration mode, more parameters are configurable. In the expert
configuration mode, all parameters are configurable without limitations. To enter the
expert configuration mode, a pin code entry is required. In the advanced configuration
mode, on the AT-1 configuration webpage, please enter the pin code and click on
Switch To Expert Configuration to open the expert configuration.
Pin Code: 3000
7.2.1 Parameter Mapping
Parameters in the simple configuration are mapped to parameters in the advanced and
expert configuration and vice versa. Therefore, it is possible to toggle between all
configuration modes seamlessly at any time.
Some simple configuration mode parameters affect multiple advanced/expert configuration
mode parameters. In such cases, if switching back to the simple configuration mode, a
direct mapping is not possible and the value ‘‘expert config’’ is shown in the affected simple
configuration field.
38
AT-1
·
Installation Manual
·
rev. 4.0
·
2020/01/09
