11
English
Français
Nederlands
* Also refer to the “INSTALLATION & OPERATION
MANUAL” for the master station (JK-1MED or JK-
1MD) connected to this unit regarding the operation
of the video door station.
A. Unlocking of user code
When the registered user code has been input using the
keypad (between 4 and 6 digits), the LED indicator (group
1: orange, group 2: green) lights up, the buzzer sounds,
and the electric door strike is unlocked.
Orange LED lights up
(during relay1 operation)
Green LED lights up
(during relay2 operation)
ex.) group 1
1006
group 2
04B2
Beep
Beep
• The time interval during which the button must be
pressed is approximately 10 seconds. If the time interval
exceeds approximately 10 seconds, the input value will
be cleared.
• If you make a mistake when inputting the user code,
input the user code again.
• When the "Lockout" function has been set, the release
function is locked and the input operation is disabled for
the specified time (10 - 99 seconds) if invalid codes are
input a set number of times (10 - 99 times). (Reference:
"Lockout".) During this time, the key illumination will
blink 4 times, the LED (orange) indicator will blink for
the set deactivation time, and the buzzer will sound for
approximately 3 seconds.
B. Timer-linked unlocking
When the timer-linked unlocking function is active, the
door can be unlocked by pressing the key during the
set time, while the timer is linked.
The
key illumination lights up when the timer is
activated by performing the setting.
C. Unlocking using the request to exit/entry button
When leaving the premises, you can activate the electric
door strike by pressing the request to exit/entry button
connected to the unit. Pressing request to exit/entry
button 1 releases relay 1, and pressing request to exit/
entry button 2 releases relay 2.
• When the door is unlocked using the request to exit/
entry button, the LED will not light up and the buzzer will
not sound.
• Operating temperature: Between -10°C and 60°C (+14˚F to
140˚F)
• Cleaning: Clean the unit with a soft cloth dampened with
a neutral household cleanser. Do not use any
abrasive cleanser or cloths.
• The unit is weather resistant. However do not spray high
pressure water on the unit directly. Excessive moisture may
cause problems with the unit.
• Press and release the
, , , and
keys
simultaneously when the Access control does not work.
* The LEDs (orange and green) will blink and the buzzer
will sound, and then resetting will take place. (The settings
do not return to their default values.)
• If resetting does not work, contact the service technician
who installed the unit.
OPERATION OF ACCESS CONTROL
TECHNICAL PRECAUTIONS
JK-DVF-AC_ENG.indd 11
2009/10/05 21:18:54
