7
WRENCH FUNCTIONS
This industrial shut off wrench is de-
signed for nut tightening/loosening
and screw driving/loosening. It is
not appropriate to use for wood/mild
steel drilling. Please refer to the fig-
ure to familiarize yourself with the
major components of this tool be-
fore use.
1. Power Switch
Depressing the power switch will
energize the LED light
(2)
in front,
and the tool starts to rotate. When
released, power to the motor
ceases and the tool stops working
immediately. The LED light will re-
main for 5 seconds, then shut off.
2. LED Light
3. Forward/Reverse Button
The tool is always in forward oper-
ation unless the Forward/Reverse
button is pressed. When the but-
ton is pressed, the blue LED light
sustains, and the yellow and
green LED lights flash together.
This indicates the tool is in reverse
operation mode. To get the tool
back in forward operation, simply
press the button again, the LED
lights shut off, and the tool is back
in forward operation mode.
4. Anvil (Drive Shaft)
The anvil will accept drive hex
socket. Be sure the socket is fully
inserted before operating tool.
Otherwise, the socket may fly off
and cause property damage or
personal injury.
WARNING:
Use only impact-
grade sleeve sockets.
5. Li-ion Battery
This battery provides electrical
power to the motor. Please charge
it according to the charging in-
struction listed in this manual.
WARNING:
Use the tool to either
tighten or loosen nuts and screws
ONLY in stipulated torque and volt-
age ranges.
4
3
2
1
5
IMPORTANT INFORMATION
1) No lights on the tool indicates
the tool is in SLEEP mode. To
wake up the tool, just press the
trigger. The tool will be ready to
use.
2) After operating the tool, the im-
pulse setting number will re-
main on the display for 5 mins.
As the number disappears, the
tool goes into SLEEP mode.
