PB-1000 PANEL BEATER
TM
PRODUCT MANUAL
PAGE 14
MAINTENANCE
PANEL
BEATER
TM
RECOMMENDED MAINTENANCE
DAILY:
PROPERLY MAINTAIN BATTERY CHARGE LEVEL (CONSULT BATTERY MANUFACTURER
RECOMMENDATIONS IF PLANNING TO STORE THE PANEL BEATER FOR EXTENDED
PERIODS, I.E. A MONTH OR MORE)
MONTHLY:
INSPECT CABLES FOR CUTS OR DAMAGE.
USE FINE STEEL WOOL ON COPPER CONNECTIONS. CLEAN MAGNET INSERT WITH
FINE
SANDPAPER.
1 YEAR
REMOVE DUST FROM CHARGER.
2 YEAR
INSPECT BATTERY TERMINAL CONNECTIONS. CLEAN IF NEEDED.
HELPFUL HINTS
• Not keeping your battery fully charged after use will decrease the life of your battery.
• When dent pulling or shrinking, the limiting factor is heat, not battery power.
• Gases from battery vent out of the machine.
• Baking soda should be used to neutralize battery acid in the event of a spill.
• Keep tip tapered to a pencil like 1/8” diameter flat tip.
• A deterioration of dent pulling performance can be noticed if dent pulling electrodes are over heated.
Cool electrodes by dipping the electrode in cool water or by pausing dent pulling to air cool.
