AGROSE ATT-1000, Owner'S Manual

Page: 14 / 38

10
3.
USER’S INSTRUCTIONS
DESCRIPTION OF THE MACHINE
The atomizers consist of a structural steel frame and a polyester tank
reinforced with fiberglass or high-density polyethylene. The frame is hot
galvanized.
The tank is easy to empty and this makes it possible to use the
machine even on hillsides.
The pumps are generally diaphragm pumps but in some cases they
are fitted with pistons.
The accessories for completing the fitting, non-drip jets and ceramic
nozzles make the AGROSE atomizer a highly qualified and efficient
piece of equipment
.
HAND WASHING TANKS
The atomizers are supplied with an auxiliary hand-washing tank with clean water and a hand tap.
This tank must always be supplied with water and the inside must be clean so you can wash any parts of
the body that come into contact with the chemical product used.
Never drink the liquid inside.
PRELIMINARY CHECKS
When you receive the machine, check that it is complete and no parts are missing.
If there are any damaged parts, inform your local reseller or AGROSE directly in good time.
When the machine is delivered, make sure you ask:
a) That the machine is delivered with all of its parts fitted and that the fitting meets the requisites in table
N° 3A-3B-
This procedure is necessary because for reasons of space during transportation the machine
is often delivered partially dismantled.
b) That it is tested in your presence in particular checking:
That the suction filter and the inside of the tank are clean and free of work residues.
That the connections are made correctly following the basic layout (PICTURE 14).
That the hose clips and all the unions and connections are tightened properly.
That all of the protective covers are fitted solidly to the machine, in particular the protective cover of the
power-takeoff of the pump.
That the multiplier is sufficiently supplied with lubricant
oil.
That the zone where the fan turns hasn’t been bent
by knocks during transportation.
For Movement and transportation the use of the trucks
or ramps is recommended, taking care for it to be fully
fastened to prevent accidents due to poor positioning.
Under no hypothesis operate the equipment without
its protection covers or the protection cover on the
drive shaft
Equipment fastening to the cart or truck shall be
performed by the tying points (see figure below). Any tying carried out at random, while appearing to be safe and
secure, is extremely dangerous and can cause serious accidents. If in doubt, contact us.
PICTURE 4