AG-tronik M1 AND REGULATOR PR-9
INSTRUCTIONS FOR USE – rev. 2017-04
24
Press key
to move the frame to the value of parameter flow/nozzle. Press key
and the value start to blink. Set new value with keys
and
. Press key
again
and the display changes the value of common flow (in our case the value is set to 17,60 1) and
in the lower left corner –MEASUREMENT- is displayed. The display disappears after 30
seconds, and the display shows new value in the line imp/l (in our case – 100).
Figure 27 Figure 28
Figure 29
Note:
during entering or measurement in the window KNOWN FLOW, flow through nozzles
must be the same as with measurement with gauged flask!
Entering common flow through nozzles is done in the same manner as entering flow/nozzle.
Use button
to return to basic image of menu "FLOW CONSTANT".
Control “KNOWN FLOW” can be done also during spraying to perform a more precise
measurement by regarding viscosity of the chemical.
Correction:
Constant correction of flow sensor is the most accurate measurement. It is done, when the
first tank has been sprayed. The positive side of correction is that a measurement with
chemical is performed, therefore correct density of chemical is regarded, and the down side is
that it can only be executed, when the first tank is emptied.
Measurement starts before the start of spraying. At that time, daily counter of spray
consumption must be set to "0" (chapter PROGRAMMING, Erasing daily counters of spray
consumption (l), surface area (ha) and path (km)). Spraying follows. When complete (known)
capacity of chemical substance has been used, e.g. 400 l, and value 393 l is displayed on
basic readout under section l, correction must be performed. Follow the procedure below to
perform correction:
