7
FIGURE 13
17
17
21
21
FIGURE 14
24
27
16
34
5
33
21. Install two cotter pins (27) in the rear hopper tube.
Bend ends of cotter pins around tube.
22. Slide the dump handle clip (33) onto the dump handle.
23. Attach the dump tube to the rear hopper tube using a
U-clamp (34) placed between the cotter pins, a 1/4"
x 1-1/2" hex bolt (16) and a 1/4" nylock nut (24). See
ÚGURE
24. Swivel the dump tube so that the end of the tube
rests on the ground behind the bag and supports the
rear of the bag in an upright position.
20. Secure the top and bottom hopper tubes together
using two 5/16" x 3/4" hex bolts (17) on inside and
TWONYLOCKNUTS OUTSIDE3EEÚGURE
FIGURE 15
25. Insert the hopper support rods (7) into the hole
beneath the curved head bolt
(26) in each upper
hopper tube. Flex and insert the rod into the hole in
THEBOTTOMREARHOPPERTUBESASSHOWNINÚGURE
NOTE:
4HEHOPPERSUPPORTRODSWILLÛEXABOUTASMUCH
ASSHOWNINÚGUREWHENTHEYAREASSEMBLED
FIGURE 16
2
23
26.
3LIDETHEPIVOTROD THROUGHTHEÛAPINTHEBAGS
WINDSCREENÚRSTANDTHENTHROUGHTHEHOLEINEACH
UPPERHOPPERTUBE3EEÚGURE
27. Hammer a palnut (23) onto each end of the pivot rod .
3EEÚGURE
HINT:
Place the bag on its side on a hard surface to
make installation of palnuts easier.
7
7
26
7
