4
9. Place one side panel in position against a side
angle and down on top of the front panel. Start one
1/4" x 1" screw through the
center hole
in side
panel and side angle. Secure with hex nut and flat
washer. See figure 6.
Make only finger tight at
this time.
10. Start one 1/4" x 1-1/4" screw through front hole on
side panel and side angle. Start another 1/4" x 1-1/4"
screw through top hole on side panel and front
angle assembly. Next, place a support strap over
these two screws and secure it with flat washers
and hex nuts,
making only finger tight at this
time.
See figure 6.
11. Repeat steps 9 and 10 for the other side panel.
12. Assemble one 1/4" x 1" screw through bottom hole
in side panel and front angle assembly. Secure
with a flat washer and hex nut,
making only
finger tight at this time.
See figure 7.
13. Repeat step 12 for the other side panel.
14. Place the axle through axle sleeves as shown in
figure 7. Refer also to figure 11 on page 5.
Tighten
all loose nuts and screws securely at this time.
FIGURE 7
FIGURE 8
15. Lay the cart down on the floor so that the sides are
up in a normal position. Remove the front panel by
sliding it up, then remove the four large washers
you used for shims. See figure 8.
FIGURE 6
