2
RULES FOR SAFE OPERATION
1/4" x 1"
1/4" x 2"
1/4" x 1-1/4"
3/4 x 1-1/2
1/4" WASHER
1/8" x 1-1/4"
1/4-20
TUBE CAP
A
B
C
D
E
F
G
I
FIGURE 1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Screw Driver
(1) Pliers
(1) 7/16" Wrench
When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers
to the outside.
The bottom panel has one galvanized
edge; this is the rear. The front edge
has three holes. See figure 2.
NOTE
2. Line up three holes in bottom panel with holes in
front angle assembly. Start three 1/4" x 1" screws
through bottom panel, then through angle. Secure
screws with flat washers and hex nuts. Tighten
securely. See figure 2.
1. Lay the front angle assembly down (flat) on floor
and stand the bottom panel in position as shown in
figure 2.
FIGURE 2
HARDWARE REFERENCE CHART
Your Farm/Yard Cart carton contains a hardware
package with parts as shown in the chart below and in
figure 1.
REF. QTY.
DESCRIPTION
A
8
Screws, 1/4-20 x 2" Long
B
4
Screws, 1/4-20 x 1-1/4" Long
C
13
Screws, 1/4-20 x 1" Long
D
4
Tube Cap, 1" x 1" Long
E25
Hex Nuts, 1/4-20 Thread
F
25
Flat Washer, 1/4" I.D.
G
4
Flat Washers, 25/32" I.D. x 1-1/2" O.D.
I
2
Cotter Pins
Contents of Hardware Pack: (See figure 1)
Preventing accidents is the responsibility of every
equipment operator. The following general safety
precautions must be fully understood and followed by
every operator.
1. Do not at any time carry passengers in this cart. It
is designed for carrying materials only and not
intended to carry passengers.
2. Be careful on any grade (hill) and stay off of steep
grades.
3. Use caution when loading cart to avoid tipping.
4. Avoid large holes and ditches when transporting
loads.
