3
3. Turn the front angle assembly and bottom panel
upside down as shown in figure 3.
4. Lay the two side angles on the bottom panel so
that the axle sleeves are closer to the front angle
assembly. See figure 3.
5. Secure both side angle assemblies to the bottom
panel using six 1/4" x 1" screws, flat washers and
hex nuts. Make only finger tight until all six screws
are in place, then tighten securely. See figure 3.
FIGURE 4
FIGURE 5
8. Lay the front panel down onto the front angle
assembly, on top of the four large washers. See
figure 5.
FIGURE 3
6. Stand the cart on its front end with the front angle
assembly on the floor. See figure 4.
7. Temporarily place four large 1-1/2" dia. flat wash-
ers (used on wheel axle) on the inside of front
angle assembly. See figure 4.
These washers act as shims and are
just for assembly purposes. You will
remove them later to use on axle.
NOTE
