13
1. System will not operate with
remote or toggle switch.
(Cannot hear a clicking noise
from receiver inside control
box.)
a. If system has a master control
switch, make sure it is turn to
“ON” position.
b. Verify correct wiring of system.
See wire schematic Page 5.
c. Auto circuit breaker may have
tripped. Wait several minutes
and try again. If it still does
not work circuit breaker may have
detected a continuous short and
short must be repaired. (Refer to
troubleshooting sequence on
Page 12.)
Trouble Shooting Receiver
(Assuming Remote is working properly)
2. System will not operate
with remote or toggle switch.
(Can hear a clicking noise
from inside receiver control
box – but nothing happens.)
Problem Issue:
Check or Try...
a. Verify there is a least 12 volts
coming into receiver on battery
hookup posts.
b. Verify there is at least 12 volts
coming out of motor terminals
on box while on/off switch is
being activated. If there are 12
volts coming into receiver and not
12 volts coming out problems
may be in receiver.
c. Verify there is at least 12 volts
at terminals on motor (use
caution around moving parts). If
there is 12 volts at the motor
and the motor still doesn’t turn,
the problem may be in the motor.
If there are 12 volts coming out
of receiver and not 12 volts going
into motor problem may be in
wire between receiver and motor.
