9
INTRODUCTION
This machine is a special, high frequency PMSM (permanent magnet synchronous motor) power tool which
must be used in conjunction with its high frequency power converter for its power supply. This converter
takes 220 to 480V, 50Hz or 60Hz, single or three phase supply and converts it to up to 600Hz for use with the
motor. Connection between the converter and motor is made by a motor coupling cable with special plug.
The converter has a three phase power supply plug and a single phase adaptor plug for use with single phase
supply. Maximum performance is obtained using 380V to 480V, three phase power supply. Performance will be
reduced when using 220V to 240V three phase or single phase supply due to electrical current limitations.
This machine is equipped with two handles and a blade guard. It has an integrated water feed system as
required for cooling and diamond cutting. The power converter has a built-in residual current device (RCD)
for electrical safety as well as overload, thermal, under voltage and over voltage protection. It must only be
used with a diamond blade. It is intended for cutting masonry, stone, concrete, reinforced concrete and similar
materials. All other uses are prohibited.
LIST OF CONTENTS
•
Concrete Saw
•
Power Converter
•
Water Coupling Hose
•
Single Phase Adaptor Cable
•
Guide Roller Assembly
•
M17 Combination Wrench
•
Splash Guard
•
Flush Cutting Kit
ASSEMBLY
•
Mount the blade. ( See below “Mounting the Blade”)
•
Mount the Guide Roller Assembly if desired ( See below “Guide Roller Assembly”)
•
Mount the splash guard (See below "Splash Guard" for assembly instructions)
DIAMOND BLADES
Allowed Types Of Blades
This machine may only use diamond blades
•
Only use either segmented or continuous rim diamond blades.
•
If the diamond blades are segmented, the maximum allowable peripheral gap between segments is
10mm and must be with a negative rake angle.
•
Only diamond blades of 457mm (18") or less may be used.
•
Blade thickness must be at least 2.0mm and no greater than 6.35mm
