Agilent Technologies E4428C ESG, Installation Manual

Page: 19 / 66

Chapter 2 13
Getting Started
Configuring the Display
With the screen saver on, the display light is turned off after a defined period of time with no input to the
front panel. The display light turns on again when any front panel key is pressed or when a remote command
is sent. The screen saver is set to off at the factory.
Press
Utility
>
Display
>
Screen Saver Mode
.
This toggles the screen saver mode between light-only mode and light-and-text mode.
Adjust the screen saver mode to turn the light on, off, or to turn both the light and text on and off. Setting the
mode to light-only mode turns the display light off, leaving the text visible at a low intensity. If the display
remains unchanged for long periods of time, set the mode to light and text to prevent the text from burning
the display. This mode turns the display light and the text off.
Press
Utility
>
Display
>
Screen Saver Delay:
.
This adjusts the amount of elapsed time before the screen saver is activated.
The screen saver delay is set to 1 hour at the factory. The current screen saver delay is displayed in the
softkey label in addition to the active entry area. To change the delay, enter a new value using the numeric
keypad or by rotating the front panel knob and then press
Enter
. The acceptable range of the delay value is 1
through 12 hours (1 hour increments).
The screen saver settings are persistent states; they are not affected by a signal generator preset or power
cycle.
Updating the Display During Remote Operation
Press
Utility
>
Display
>
Update in Remote Off On
.
This toggles the display-update-in-remote mode on or off.
When toggled on, commands executed via the remote control bus will update the signal generator display
accordingly. When toggled off, commands executed via the remote control bus will not update the signal
generator’s display. Update-in-remote mode is set to off at the factory.