Agilent Technologies E2730A, Installation And Operation Manual

Page: 56 / 75

E2730A VXI RF TUNER
OPERATION 3-23
Table 3-13. Compatibility Messages (Continued)
Command Response Description
#CBW nrf,nrf,...nrf CHN 0 Set IF Bandwidth Data
CHN? CLG nr1,nr1,...nr1 Request current memory channel accessed for
sweep or step operation.
#CLG? Request dBm Table. Always returns 0.
CLT nrf Set COR loss timer.
CLT? CLT 0000 Request current COR loss timer value.
CMP nrf,nrf Set the sweep data compression ratio.
CMP? CMP 001,1 Request the status of the sweep compression ratio
selection.
COD nrf Set COR Output Delay Timer - IGNORED
COD? COD 0 Query COR Output Delay Timer Setting – always
returns 0
COR nrf Set COR level.
COR? COR 00 Request current COR level.
CQU Clear the signal queue.
CST? CST 1 Request current COR status
#CVB nrf,nrf,...nrf Set Video Bandwidth Data – IGNORED
DBM nrf Set data representation in SSD buffer
DBM? DBM 0 Request current SSD data representation.
DBT nrf Set data width (number of bits) in Digital Scan
Output
DBT? DBT 8 Request Digital Scan Output data width
DCM nrf Set DSP Clock Mode
DCM? DCM 0 Request Current DSP Clock Mode
DCR nrf Sets the value of the Delta COR parameter.
DCR? DCR 0 Request the value of the Delta COR parameter.
DDF nrf Sets the value of the Decaying factor parameter.
DDF? DDF 0 Request the value of the Decaying factor parameter.
DET nrf Select detection mode.
DET? DET 1 Request current detection mode.
DIM nrf Set DSP Idle Mode
DIM? DIM 0 Request DSP Idle Mode Status
DIS nrf Setup Digital Interface
DIS? DIS 0 Request current digital interface setup.
DRF nrf Sets the value of the Rising factor parameter.
DRF? DRF 0 Request the value of the Rising factor parameter.
DSO nr1 Turns Digital Scan Output ON and OFF –
IGNORED