Agilent Technologies DSO9024H, User Manual, Page: 15 / 102

Setting Up the Oscilloscope
15
To connect a mouse, keyboard, LAN cable, USB device,
and printer
See Figure 1-2 on the next page for the location of the side panel connectors
described below.
Mouse The mouse can be plugged into either a USB port or into a PS2 port.
There are several USB connectors on the front panel or the side panel of the
oscilloscope that can be used. When using the PS2 port, the mouse must be
plugged in prior to turning on power to the oscilloscope
Keyboard The keyboard can be plugged into either a USB port or a PS2 port.
There are several USB connectors on the front panel or the side panel of the
oscilloscope that can be used. When using the PS2 port, the keyboard must be
plugged in prior to turning on power to the oscilloscope.
LAN Cable Connect your LAN cable to the RJ-45 connector on the side panel
of the oscilloscope.
USB Connectors Side panel USB connectors can be used for any USB
devices. There are also three USB connectors in the lower right corner of the
front panel.
Printer Cable
If you have a parallel (Centronics) printer, you will need a
parallel printer cable. Connect the cable to the parallel port on the side panel
of the oscilloscope.
If you have a serial printer, you will need a 9-pin to 25-pin serial printer cable.
Some printers may require other cable configurations, but the oscilloscope has
a 9-pin serial connector. Connect the cable into the RS-232 port.
After you have connected to the LAN card, you must set up the network. Before you start
to set up your network, you should exit the oscilloscope application.