Agilent Technologies aurora Duet, User Manual

Page: 82 / 236

5 - 16 428856
aurora
Duet
Basic & Primary Rate ISDN Tester - User Guide
Choosing the type of Monitor trace output
To define the tracer setup, use the arrow keys to switch
between the available options. The types of output that are
available to you will depend on whether
aurora
Duet
is in
MONITOR or SIMULATE mode.
TRACER
You can choose between
TO
MEMORY, EXPERT TO COMMS,
DECODE TO COMMS, SIMPLE TO
COMMS, TEST TO COMMS,
RESULTS TO COMMS
and
OFF
.
TRACER
You can choose
TO MEMORY
or
EXPERT TO COMMS
.
Types of output available
Depending on whether your aurora
Duet
is in MONITOR or
SIMULATE mode, you can select from the following types
of output:
TO MEMORY
Layer 2 and 3 data is stored in
the memory for use with the
TRACE CAPTURE REVIEW
menu.
For more information, see
Chapter 7.
If you choose
TO MEMORY
, a
MODE
setting appears, which
you can set to
FILL
or
WRAP
. In
FILL
mode data is stored until the
memory is full. In
WRAP
mode
data is stored continuously, and
when the memory is full the
oldest data is replaced by new
data.
EXPERT TO COMMS
This output is used for
communication with other
products, currently
aurora
Expert
.