2-4
General Information
Operating
Receivers
Figure 2-2. Front and rear panels on a receiver
Front and rear panel features
While the
DC IN
connector provides a connection to power the receiver, the
DC OUT
connector can be used to power to another source or receiver.
The front-panel
OPTICAL INPUT
connector has a special adapter which allows
you to easily change the front-panel connector to one of many standard inter-
faces.
Refer to “Replaceable Parts” on page 2-5
for a figure which shows each
available connector. For Agilent 83411C/D receivers, use a single-mode 9
µ
m
optical fiber. For Agilent 83410C and Agilent 83412B receivers, use an
62.5
µ
m multimode optical fiber.
The
AVG POWER
connector provides an output voltage that is proportional to
the average optical power into the receiver.
The
OVER ILLUMINATION
light turns on whenever RF input power is too high.
The
POWER ON
light turns on when DC power is supplied.
The
RF OUT
connector provides the output for the demodulation (electrical)
signal. It is an SMA threaded female connector.
Summary of Contents for 83400 Series
