Agilent Technologies 83400 Series, User Manual, Page: 16 / 82

1-5
Getting Started
Connecting a Source
Connecting a Source
1 For Agilent 83402C products, perform the following two steps:
a If you are located outside of the United States or Canada, locate the yellow
sheet of IEC laser classification and laser safety labels supplied with the
source. Labels are provided for most major languages.
b Select the two labels in the desired language, and place them on the source
at the two positions shown in
Figure 1-2 on page 1-6 . FDA labels should al-
ready be located at these positions.
W A R N I N G Do NOT, under any circumstances, look into the optical output or any
fiber/device attached to the output while the laser is in operation.
2 Connect a terminated fiber-optic cable or device to the source’s
OPTICAL OUTPUT
connector. This protects the user from exposure to laser radiation. See
Figure 1-3 on page 1-7 .
3 Connect the DC cable, supplied with the source, between the source’s rear-
panel
DC IN
connector and a
PROBE POWER
jack.
You’ll find
PROBE POWER
jacks on the following products:
• Agilent 8702A/B/D lightwave component analyzer
• Agilent 11899A probe power supply
4 Make sure that the BNC short is connect to the rear-panel
REMOTE SHUTDOWN
connector.
The source will not operate without the BNC short connected.
5 Insert the key into the source’s front panel.
6 Turn the key to turn the source on.