AGI WHEATHEART X Series, Assembly And Operation Manual

Page: 74 / 126

3. A
SSEMBLY
W
HEATHEART
- X-S
ERIES
13" A
UGERS
3.18. I
NSTALL THE
H
ITCH
J
ACK
X130-74, X130-84, X130-94
74 30787 R2
3.18. INSTALL THE HITCH JACK
The jack is attached to the auger with a pin at the pivot point. To install:
1. Elevate the auger boot (intake end) approximately 2’ (5.08 cm) with a front-
end loader and sling, and install the jack in a vertical position. Secure with
supplied pin.
2. Place a board beneath the jack before setting it on the ground, then lower the
auger until the jack is seated. Remove front-end loader from auger.
Note: Jack can be rotated 90° for transport or operation.
3.19. CONNECTING THE PTO DRIVELINE
Table 3.16 provides a list of parts required to connect the PTO driveline.
1. Install the PTO transport strap using two 1/2” x 1-1/2” bolts and two
1/2” nuts.
2. Clean paint or dirt off of PTO driveline and flighting shaft ends before
assembly.
3. Ensure that the 3/8” x 2-1/2” square key is in place on the flighting shaft.
4. Slide plain end of PTO driveline onto flighting shaft. Make sure that the
3/8” holes are lined up.
5. Carefully tap in a 3/8” roll pin. Tighten the set screw on the PTO shaft.
6. Install the sprocket shield on the boot using four 5/16” x 3/4” bolts.
7. Loosely install the sprocket shield on the boot using four 5/16” x 3/4” bolts.
8. Slide the PTO transport saddle through the support strap on the boot and
rest the PTO driveline in it.
9. Install the sprocket shield using four 5/16” x 3/4” bolts and locknuts.
WARNING
Jack is designed for raising or lowering auger
hitch only.
Do not get on or beneath auger while
supported by or while jack is being operated.
Table 3.16 Parts Required, Connecting the PTO Driveline
Part Number Description Amount
20042 PTO transport strap 1
18537 PTO transport saddle 1
29140 PTO CV driveline 1
20062 Sprocket cover 1
18546 3/8” roll pin 1
18541 3/8” x 3-3/8” square key 1
19589 1/2” x 1-1/2” bolt 2
19599 1/2” locknut 2
19538 5/16” x 3/4” bolts 4
19980 5/16” locknuts 4