AGI WHEATHEART X Series, Assembly And Operation Manual, Page: 109 / 126

W
HEATHEART
- X-S
ERIES
13" A
UGERS
7. M
AINTENANCE
X130-74, X130-84, X130-94 7.3. M
AINTENANCE
P
ROCEDURES
30787 R2 109
7.3.9. S
PEED
R
EDUCER
G
EARBOX
O
IL
L
EVELS
A
CCESSING
G
EARBOX
Remove the hairpin securing the gearbox safety cover, fold up the safety cover,
and service gearbox as required. Replace and secure the gearbox safety cover
after service is complete.
C
HECKING
O
IL
L
EVEL
The speed reducer gearbox should be level when checking or refilling oil.
1. Remove the oil filler plug located to the right of the lower flight gearbox shaft.
2. Insert an improvised dipstick (rolled paper or plastic tie) into the oil filler hole
to determine the oil level. Note the level and the condition of the oil.
a. If the condition of the oil is poor, consider replacing the oil ahead of
schedule.
b. If the oil level is not within 1/4” [5 mm] of the oil filler plug, top up the oil
level. Do not overfill.
3. Replace the oil filler plug, ensuring that it is tightened firmly.
7.3.10. M
ACHINE
C
LEANING
1. Clean out excess grain from auger tube, boot, and hopper.
2. Make sure water can drain from the auger tube and hopper and then wash
the tube with a water hose or pressure washer until all dirt, mud, debris, or
residue is gone.
3. Provide sufficient time for the water to drain from the auger.
7.3.11. T
IRE
P
RESSURE
C
HECK
With a tire pressure gauge, check each tire to make sure it is between 18–24 psi
(124 - 165 kPa).
• Ensure tires are cold prior to checking pressure.
7.3.12. W
HEEL
B
EARINGS
R
EPACK
1. Remove the wheel bolts and the wheels.
2. Remove the wheel bearing and pack with grease. Refer to page 102 for
recommended grease.