42
7713397 R2
Figure 29.
Position Auger Assembly and Tighten Lock Collars
Tighten locking
collars on
insert bearings.
12. Using four 3/4" x 5" threaded rod and hardware, assemble the level auger cover plate and motor mount
base to the side skirts.
13. Using 1/4" hardware, assemble the pitched level auger covers to the side skirts.
Figure 30.
Assembling the Motor Mount Base to the Side Skirts
3/4" Hex Nut
(HN)
3/4" Threaded
Rod
Motor Mount Hardware
1/4" x 3/4" Hex Bolt (HB)
1/4"
Flatwasher
(FW)
1/4" Whizlock
Nut (WL)
Cover Hardware
Motor
Mount
Base
Cover Plate
Motor
Mount
Base
Cover Plate
14. Using 5/16" x 1" HB, FW, LW and HN, bolt the motor onto the motor mount pivot plate.
15. Using 5/16" x 2-1/2" carriage bolts (CB) and wing nuts (WN), attach the motor mount pivot plate to the
motor mount base.
16. Using a 1/4" x 1/4" x 2" key, attach the driver pulley to the motor shaft.
17. Using 3/8" hardware, bolt the belt shield mounting plate to the level auger belt shield bracket.
18. Using 1/2" hardware, attach the level auger belt shield bracket to the end plate.
CONTINUOUS-FLOW GRAIN DRYER – COMMANDER CONTROL