44
30549 R1
6.2. Auger Drive and Lockout
A: PTO Driveline
1. Ensure that the PTO driveline is securely attached to the flighting shaft and to the tractor.
2. Do not use a PTO driveline without a rotating shield that is in good working order.
3. Be certain that safety shields are in place and secure on tractor and auger.
4. The maximum operating length of the PTO driveline from end to end is 40-5/8". Do not exceed this length.
Note
If shearbolt in the PTO driveline fails, shutdown and lock out tractor to replace bolt.
The MK/HX 10-36 uses a 5/16" x 1" grade 8 bolt — through shank shear (as per drawing).
5. Be sure the PTO drive on tractor is in the OFF position before starting the tractor.
6. Stay clear of the PTO hazard area (see
Lockout and/or Shutdown
1. Shut off engine and remove ignition key or coil wire from tractor.
2. If step 1 is not possible, remove PTO driveline from tractor.
6.3. Start Up and Break In
Start up and break in procedure for the MK/HX 10-36 auger is as follows:
Note
The angle drive requires a break-in period of at least 2 or 3 loads of grain.
1. Ensure that you have completed the pre-operational checklist in
Section 6.1 – Pre-Operational Checklist on
2. If everything is satisfactory, prepare for a 60 minute operation at half speed.
3. Ensure that the intake hopper is correctly positioned.
4. Ensure that the PTO drive on the tractor is in the OFF position.
Do not start auger until area is clear of all unauthorized personnel. Always work with a
second person during operations.
Auger must be hooked up to tractor for all operations, including transport, raising,
placement and augering of grain. Disconnect PTO driveline from tractor for transport and
placement.
Important
When starting auger for the first time, be prepared for an emergency shutdown in case of excessive
vibration or noise. Note that the auger may run rough until tube is polished.
5. Start tractor and
idle at low RPM
. Slowly engage PTO drive.
MK/HX 10-36 – SWING-AWAY GRAIN AUGER
