22
30549 R1
Figure 13.
Assembling the Wheels
1
2
3
4
Do not remove tube support until assembly at end of section has been completed.
Figure 14.
7. Place undercarriage beneath tube assembly, then position stabilizer braces (A) as shown in
and
attach lower reach arms to bracket welded on lower end of auger tube with two 3/4" x 2" bolts and
locknuts.
DO NOT OVERTIGHTEN.
Tighten snug only as these bolts act as pivot points.
8. Fasten flat braces (B) to first set of holes (furthest from intake) on stabilizer braces (A) with one 7/16" x
1-3/4" bolt and locknut. Place one 7/16" x 1" bolt and locknut in other hole of stabilizer brace.
9. Attach upper lfit arms to the roller trackshoe with one 3/4" x 6-1/2" bolt and locknut.
DO NOT
OVERTIGHTEN.
Tighten snug only as this bolt acts as a pivot point.
10. Lower upper end of auger slowly until track shoe rests against upper trackstop.
MK/HX 10-36 – SWING-AWAY GRAIN AUGER
