AGI MK/HX 10-36, Assembly & Operators Manual

Page: 21 / 54

30549 R1 21
3.4. Transport Undercarriage Assembly
To assemble undercarriage:
1. Fasten the lower reach arms to the axle with three 1/2" x 1-1/4" bolts and locknuts on each side.
2. Attach long crossmember to bottom of large frame brackets as shown, with two 7/16" x 1" bolts and
locknuts.
3. Attach short crossmember to small frame brackets loosely with two 1/2" x 1-1/2" bolts and locknuts,
sandwiching the flatbraces (B) between short crossmember and small frame brackets on each side. Leave
this way until step no. 8. (See
Figure 15 ).
4. Check that pressure of pre-inflated tires matches pressure indicated on the tire sidewall. Mount wheels on
the hubs using four 1/2" x 1" wheel bolts in the pattern indicated on Figure 13 .
5. Fasten upper lift arms to lower reach arms with two 3/4" x 2" bolts and locknuts. DO NOT OVERTIGHTEN.
Tighten snug only as these bolts act as pivot point.
6. Raise the discharge end of auger with a front end loader and a strong sling or chain, or block and tackle, as
shown in Figure 14 . Height should be sufficient to clear undercarriage assembly.
Figure 12.
MK/HX 10-36 – SWING-AWAY GRAIN AUGER
3. ASSEMBLY