AGFEO AS 181 plus, User Manual

Page: 185 / 220

3 - 17
Programming your
System
ST 25 DECT 30 ST 30
Downloading new software
The AGFEO ISDN Telephone System can be upgraded to the lastest software version,
without the need to change any hardware. New software can be loaded into the telephone
system using a PC connected to the RS 232 c connection. Software can also be loaded via
an internal SO Bus providing the PC has an ISDN Card. New software may also be loaded
remotely by your dealer via the ISDN telephone line.
Connect ion via RS 232 C Bus
- Connect the telecommunications system’s RS 232 interface (D-SUB-9 socket) to the
PC’s COM port.
For connection, use the PC cable belonging to the telecommunications system or a one-
to-one V.24 extension cable featuring a male and a female connector (mouse or joystick
extension cable). It must not be more than 3 m long.
Save Configuration Data
- Start the "TK-Set" configuration program on your PC
- Read out all data of the system (F8).
- Save the data on the hard disk or on a diskette.
System requirements
Update you software
- IBM- or compatible PC with hard disk and CD ROM drive
- Pentium II 233 MHz or higher
- at least 64 MB RAM
- Microsoft Windows 98/2000/ME/XP
- RS 232 C-or USB interface
- Unpack the Firmware Update Files into the "Updates" subdirectory of the TK-Soft direc-
tory on your hard disk (eg. "C:\TKSoft\updates").
- Start the "TK-Flash" update program
Refer to the online help for details of how to operate "TK-Flash".
The new software is now loaded into the telecommunications system. You cannot make
any telephone calls during the load operation (approximately 5 minutes). You can observe
the load process on the PC’s monitor.
- End "T K-Flash ".
- Clear the telecommunications system’s memory from the system telephone or from an
a/b telephone. (page 3-15)