15
Install Kit 4506B
The shield for your baler will mount on top of the sheet metal directly above the pickup head shown in the
picture above. Mount shield holder (001-4703H) on top of metal 6 inches from the front of the baler and 10
inches from the side of the baler. Attach this holder with 1/4 x 1 1/4" self-tapping bolts. Place shield of top of
holder and rotate the shield to a 45-
degree angle. Mark the location of the next holder’s position and install.
Four holes will need to be drilled below the tips using a 3/4" hole saw or bit.
Install Kit 4507B
The shield for your baler will mount on the wrap guard as shown in the picture above. Remove the
two outside bolts on each side of the wrapper guard. Place bracket 001-4703G so pins are facing up
and bolt through with 3/8 x 1-1/2" into bracket 001-4703G, through wrap guard, and into threaded
holes on baler frame that the bolts were removed from.
Outside
bolts
001-4703G
10 inches
6 inches
from the
front
001-4703H
For AGCO part cross-reference visit: www.harvesttec.com/system.html
