Torque values: diesel engine (DEUTZ TCD 6.1)
Chassis number 738/../ to 743/../
Oil sump cap screw
(replace copper washer)
55 Nm
Flywheel to crankshaft
NOTE:
Tighten the bolts in the specified sequence.
Use new screws each time they are loosened.
M10x1 x85
Stage 1: 30 Nm (pre-load value)
Stage 2: 60° (re-tightening angle)
Stage 3: 60° (re-tightening angle)
M10x1 x80
M10x1 x75
M10x1 x70
M10x1 x55
M10x1 x50
M10x1 x45
M10x1 x40
M10x1 x35
M10x1 x30
Stage 1: 30 Nm (pre-load value)
Stage 2: +60° (re-tightening value)
Stage 3: +30° (re-tightening value)
Poly V ribbed pulley to crankshaft
Note:
Tighten the bolts in the specified sequence.
Use new screws each time they are loosened.
Stage 1: 40 Nm+10 Nm (pre-load value)
Stage 2: +60° (re-tightening value)
Stage 3: +60° (re-tightening value)
Flywheel housing M12/M16
99 Nm/243 Nm
Front cover
21 Nm
Injector clamp
20 Nm + 3 Nm
Cable connection at Y095 ... Y098, Y100, Y101 injector
1,5 Nm
Grooved nut to cable connector
10 Nm
1. Tractor
1-44
FENDT 700 Vario S4
X990.005.538.013