31
DESN 512391 B
Levelling
The appliance is fitted with mobility rollers, two at the rear
and two at the front.
The AGA 6-4 is designed to stand on a flat and level surface,
however, any unevenness may be overcome by adjusting
the four levelling feet, one at each corner of the base plate.
The adjusting screws are accessed by removing left and right
hand hotplate castings
page 37
. To raise the cooker turn
screw clockwise, to lower turn screw anti-clockwise.
There are rollers on the base of the cooker to allow for
positioning.
When the appliance is in the correct position the four
levelling feet can be adjusted to level the cooker.
THE FEET
MUST BE LOWERED ENOUGH TO PREVENT THE COOKER
ROLLING OUT OF POSITION
(
Fig. 12.3
).
Cooker stability
A stability bracket
MUST BE
secured firmly to the fabric of
the building, when the appliance is connected to the gas
supply by a flexible hose. For positioning of bracket (
Fig.
12.1
).
A safety chain must also be anchored firmly to the wall and
appliance to prevent the flexible hose from straining, when
the cooker is withdrawn for servicing. When fitting a stability
bracket and chain refer to dimensions in (
Fig. 12.1
) and (
Fig.
12.4
).
If disconnection of the restraining chain is necessary, then
ensure restraining chain is re-attached as appliance is
relocated in its original position to avoid serious injury or
fatality.
Reassemble the burner caps (
Fig. 12.9
) and (
Fig. 12.10
), wok
burner (
Fig. 12.11
) and re-fit the pan support.
Fig. 12.3
DESN 517163
Fig. 12.4
