CONVERSION
Check the appliance is electrically safe and gas sound when you have finished.
38
ArtNo.102-0007 - Maxitrol converter device positions
ArtNo.103-0006 - Maxitrol cap & converter
Nut
Snap-in converter device
Fig.8-7
ArtNo.102-0005 - Gas regulator types
Fig.8-5
ArtNo.0102-0011 - Screwing
the control valve bypass screw
Fig.8-3
Fig.8-4
Fig.8-6
Natural Gas &
Propane Gas
Centre burner
49
Large burner
38
Right front burner
31
Table 8-2
Remove the electrical connections from the rear. Taking care
not to damage the control panel, and protecting it with cloth
for example, rest it on the open oven door.
Turn the bypass screw on each control clockwise to the stop
(Fig.8-3)
. Connect the electrical connectors to the rear of the
control panel and locate it over the front lip of the hob. Fit the
6 fixing screws and control knobs.
See
Table 8-2
for screw sizes.
Gas Regulator
To access the gas regulator remove the storage drawer.
Pull the drawer right out. Push the ends of the plastic clips
(down of the left-hand side, up on the right-hand side) to
release the catches holding the drawer to the side rails
(Fig.8-4)
. At the same time pull the drawer forwards and
away from the side rails. The regulator is now accessible.
For safety reasons slide the inner side rails back into the
cavity.
The regulator may be one of two types
(Fig.8-5)
.
Type 1
Unscrew the hexagonal nut in the front of the regulator. The
regulator nut has a plastic snap in converter device on the
underside
(Fig.8-6)
. To convert the regulator, snap the device
out of the nut and refit the other way up.
The snap in converter device is marked to show which gas it
is set for
(Fig.8-7)
. Make sure the device is secure in the base
of the nut and refit the nut to the regulator.
Summary of Contents for Professional 90 Dual Fuel
Page 1: ...90 Dual Fuel User Guide Installation Service Instructions U110246 01 Professional ...
Page 45: ...43 ...
Page 46: ...44 ...
