17
Connect Common on the photo eye to COM (5) on the control board.
(All Commons and Negatives from all photo eyes connect to the same
terminal COM (5) on the control board.)
Test the photo eyes by activating the gate and then blocking the beam.
The gate will reverse.
The gate will stay open as long as the beam is blocked.
As soon as the beam is no longer blocked, the gate will begin closing in 2
seconds.
INSTALLING AN AUTOMATIC EXIT SENSOR
(Also known as an Exit Wand or Exit Probe)
An automatic exit sensor is buried alongside the driveway and uses the
earth’s magnetic field to detect moving metal. When the field is disturbed
the gate is triggered to open.
Dig a shallow trench and bury the exit sensor. It is not necessary to use a
PVC conduit, but it is a good idea in order to protect it and to make it
easier to replace.
Wiring Instructions for Exit Sensors:
GATEMASTER Exit Probe
Brown --- “SWIPE” (4)
Green --- “COM” (5)
Red/White --- “VCC” (10)
Black/White --- “GND” (11)
EMX VMD202 Exit Probe
Brown --- “SWIPE” (4)
Green --- “COM” (5)
Red/White --- “VCC” (10)
Black/White --- “GND” (11)
Cartel Exit Probe
Blue --- “SWIPE” (4)
Black --- “COM” (5)
Red --- “VCC” (10)
Shield/bare wire --- GND (11)
Installing a Wired Keypad or Intercom
A wired keypad or an intercom can activate the gate by a relay which is
two wires completing a circuit. They can get their power from their own
transformer plugged into a 110V AC power source or they can get their
power from the operator control board.
EMX KPX 100 Keypad Wiring Guide:
For a Double gate:
Output 1 N.O. --- “SIDE2” (1)
Summary of Contents for GATEMASTER 900 HD
Page 1: ...1 AGA GATEMASTER 900 HD AGA GATEMASTER 900 HD Installation Manual...
Page 6: ...6...
Page 19: ...19...
