AGA GATEMASTER 900 HD, Installation Manual

Page: 16 / 23

16
How to change the programming code:
Enter the current installer code, for example 0000 (expect one long beep)
Press 69# (expect one short beep)
Key in new 4-digit installer code followed by the # key for example 4640#
(expect one long beep and one short beep)
Keypad will automatically exit programming mode
Installing Safety Photo Eye
We offer two types of photo eyes: through-beam and reflector. A
through-beam photo eye has a transmitter on one side of the driveway and
a receiver on the other side. A reflector photo eye has a
transmitter/receiver on one side of the driveway and a reflector on the
other side.
Photo eyes may be mounted on brackets mounted to the gate posts, or on
small metal or wood stakes on each side of the driveway.
For a double gate, photo eyes are mounted to shoot the beam directly
across the driveway. For a single swing gate, the photo eyes can be
mounted directly across the driveway, or they can be mounted at an angle
across the driveway as in this diagram.
One set of photo eyes is typical for a residential setup, but two sets of
photo eyes will provide more protection, especially for a busy gate or a
gate that swings out towards the road.
Wiring the Photo Eye:
If the photo eye has a “jumper”, set the jumper to NO (Normally Open.)
Connect OUT on the photo eye to IR (6) on the control board.
Connect Power + on the photo eye to 12v (7) on the control board.
Connect Negative – on the photo eye to COM (5) on the control board.