AGA GATEMASTER 900 HD, Installation Manual

Page: 11 / 23

11
◼
Using a clamp, mount the gate bracket onto the gate. Do not drill and bolt yet.
◼
Attach the operator arm to the brackets again
◼
With the release lever up, move the gates manually open and closed until they are in the
desired position
◼
Adjust the position of the brackets as needed. This cannot be changed once finally
drilled and bolted. Be sure the actuator is level and the gates are in the desired position.
◼
When the gate opens and closes to the proper position, mount the post bracket onto the
post with bolts.
-
Place the post bracket on the post and mark the drilling points. Make sure the
bracket is level. Then drill four 3/8 holes through the hinge post and fasten the
bracket with nuts and washers.
-
Note: Drilling and bolting all the way through the post is the strongest method, but
if it is not possible to drill through the post, you could use quarter inch self-tapping
screws. If that is necessary, regularly check that the screws are tight.
◼
Drill and bolt the gate bracket permanently
◼
Close and lock the release lever
◼
There are no limits to set, so at this point the actuator is ready to be powered up and
used.
POWER
Note: In case of a power failure, the operators may be opened and closed
manually by unlocking and lifting the release lever on top of the operator
arm.
The recommended power for this gate operator system is 110-120V AC.
The integrated transformer steps the power down to 24V DC to operate the
control panel and operator arms.
Please make sure to shut off the power before installation or
maintenance.
The installation of the 110V AC power supply cable to the Control Box
should be done by a qualified professional electrician.
The 110V AC power cable is already attached and the cable “pigtail”