5
6.
If equipped, disconnect the wheel arch moldings. Remove the screw, located nearest the
front of the truck in the wheel well. Pull on the wheel arch moldings carefully until it comes
off the two bottom tabs. Be careful not to break them.
7.
Starting on the passenger side, pull on the plastic bumper cap fascia till it disconnects from
the fender. After the passenger side is disconnected, move to the
driver’s
side and
disconnect it from the fender on that side. When both sides are disconnected, pull on the
plastic bumper cap fascia until it disconnects from the grille and carefully remove it.
Summary of Contents for SCORPION 79-21008L
