3
Note: Before you begin, use “Painters Tape” to apply a protective guard around the work
areas (fender and bumper valance). This will help protect the paint and finish of your vehicle.
1.
Disconnect the negative battery terminal.
2.
Locate (13) plastic clips on top of plastic shroud. Carefully pry the pins out to remove and
then set aside. Save all parts for reinstallation.
3.
Remove the plastic shroud. Set it aside for reinstallation.
Summary of Contents for SCORPION 79-21008L
