AES uScope Manual
www.AESwave.com
Copyright 2011 by Automotive Electronics Services, Inc.
Page 5
Quick Start - How To:
Charge the battery:
Charge your new uScope for at least 5 hours before first use.
Waveform Capture using a PreSet:
All presets are stored and loaded onto the SD card.
Turn on the uScope by sliding the switch located on the bottom right of unit.
1. Use the
UP | DOWN
arrow keys and highlight the
“
PS
”
(PreSets) menu item.
2. Press
“
OK
”
and the menu will open.
3. Use the
UP | DOWN
arrow keys to highlight the desired preset “Group.”
a. Sensors, Actuators, Amp, Ignition, Charging, User Set Ups
4. Press the
LEFT | RIGHT
arrow keys to select the desired preset in the “Group“.
5. Press and Hold the
“
OK
” button to activate the preset.
6. Connect your test leads and fine tune time voltage and trigger adjustments if desired.
7.
Note: To select Auto Setup, highlight Auto Setup, and press & hold “OK” to activate it.
Waveform Capture not using a PreSet:
1. Turn on the uScope by sliding the switch located on the top right of unit to the right.
2. Use the
UP | DOWN
arrow keys and highlight the
“
Tr
”
(Trigger) menu item.
3. Press
“
OK
”
and the menu will open
4. Use the
UP | DOWN
arrow keys to highlight the
“
Tr
”
Mode (Trigger Display Mode) Menu item.
5. Use the
LEFT | RIGHT
arrow keys to select
AUTO
. Note the prompt located in the top left of the
screen.
a. AUTO trigger type will allow the uScope to update the screen regardless of other trigger
settings. This is a great first step to get the signal on the display. Reference chart on
page 11.
6.
Press
“
OK
”
to exit the menu
7. Connct test leads to the signal.
8. If the signal is to short or too tall:
a. Use the
UP | DOWN
arrow keys and highlight the
“.
V
”
menu item.
b. Press
“
OK
”
and the menu will open
c. Use the
UP | DOWN
arrow keys and highlight
“
V/Div
”
d. Use the
RIGHT
arrow key to make the waveform taller. Use the
LEFT
arrow key to make
it shorter.
e.
Press
“
OK
”
to exit the menu
Continued….