AES uScope, Getting Started, Page: 12 / 12

AES uScope Manual
www.AESwave.com Copyright 2011 by Automotive Electronics Services, Inc.
Page 12
General:
The following items are helpful in understanding the operation of your scope so you can get the
most out of it.
Charging the uScope Battery:

Grab your uScope and USB cable included with your kit.

Connect your uScope to any active USB port on a PC or charging station.
Note: to verify the uScope is charging, turn on the uScope and look at the bottom left of the
screen, you should see the word “USB.” If you see a battery icon, then the uScope is connected
to an inactive USB port or not properly connected.
Note: a USB receptacle or USB wall charger can also be used to charge the uScope.
Note: Do not use the uScope on AC line signals while charging.
How to Capture a Waveform onto a PC:

Turn the uScope On

Plug the uScope into an available USB port on a computer

Note: The waveforms and presets are saved onto the uScope memory card. Never remove the
memory card, doing so will interrupt some of the uScopes functions.

The uScope memory card will act as removable mass storage once plugged into your pc.

The folder can be accessed through my computer under “Devices with Removable Storage”

The folder containing the waveform images is labeled “IMAGE”

Note: The images are organized by image number, you will need to remember the image
number.

Note: IMAGE001- IMAGE016 are the reference waveforms. DO NOT delete the images.
Firmware updates
The uScope Firmware is updating on a regular basis with improved features and functions. To
check for the latest version go to the uScope home:
www.yourdt.com/uscope
Note the firmware will only load and operate on the uScope designe by AESwave.
http://www.yourdiagnostictools.com/uscope/