Instruction manual for use and maintenance - EN
Rev.: 0
–
aggiornato al 06/11/2020
| Con riserva di modifiche tecniche e salvo errori |
Pag.
11
di
39
5.
ASSEMBLY
Risk of serious injury when assembling the suction arm due to gas spring preload. A
safety lock is provided on the metal articulating arm assembly.
Improper handling can lead to risk of abrupt displacement of the metal articulating arm
assembly, resulting in severe injuries in the face or crushing of the fingers!
The user is required to appoint a specially trained technician to install the unit.
The assembling operations require the intervention of two persons.
5.1.
Unpacking and castors assembling
The unit is delivered on a wooden pallet and protected by a cardboard box.
Pallet and box are held together by two straps.
A copy of the rating plate of the unit is applied also outside the box.
Prepare unpackaging as follows:
•
Cut the straps with scissors or cutter;
•
Lift up the cardboard box;
•
Remove any additional packages contained inside and place them on the ground in a stable
manner;
•
Using scissors or cutter, cut the strap blocking the unit on the pallet;
•
Remove any packaging materials such as bubble nylon;
•
If castors are already built in the unit, continue with this procedure otherwise go to
note A
;
•
Block the front swivel castors by the brake;
•
Let the unit slide off the pallet so that the two braked castors can rest on the floor;
•
Extract the pallet from beneath the unit and place it carefully on the ground.
Note A:
In case of supply of the unit with castors to build in, it is necessary to proceed as per following
instructions:
•
Shift the unit about 30cm off the pallet, from the front side;
•
Place the castors with brakes under the unit;
•
Assemble them in the unit using the screws that are provided in the package;
•
Shift the unit about 30 cm off the pallet, from one side;
•
Position and assemble one rear castor;
•
Extract the pallet from beneath the unit and assemble the second rear castor.
WARNING
INFO
