Aeroworks 30cc Freestyle Extra 260 Assembly Manual
31
1. Gather the items shown below for ignition
installation.
Required Parts
◊
2 - 8x80x300mm Foam Pad
◊
2 - 8x450mm Nylon Ties
Required Parts -Not Included
◊
1 - Ignition Module
◊
1 - Battery
(2600mah Li-Ion Shown )
◊
1 - Ignition Regulator
(Smart-Fly Shown )
◊
1 - Ignition Switch
(MPI Shown )
◊
4 - Aeroworks Safety Clips
Required Tools and Adhesives
◊
1 - Pencil/felt tip pen
◊
1 - Electric Drill
◊
1 - 1/16” Drill Bit
◊
1 - Wire Cutter
IGNITION
INSTALLATION
2. Position the ignition module on the side of the
engine mounting box and mark the location of
the nylon tie holes as shown.
3. Use a 1/4” bit to drill the ignition module
mounting holes.
4. Mount the engine ignition module using nylon
tie and foam rubber as shown.
6. The ignition switch mounting location is at
builders discretion. Mark the location for the
ignition switch using the switch mounting plate
for a template. Use a modeling knife to cut out
the switch hole.
Note:
Ensure ignition switch location does not
interfere with the mounting of the wing.
5. Mount ignition battery on opposite engine box
side with nylon tie and foam padding.
