Aeroworks 30cc Freestyle Extra 260 Assembly Manual
29
6. Install the servo mount to the inside of the en-
gine box as shown. Use tape or clamps to en-
sure the servo mount does not move until the
epoxy sets.
7. Assemble ball link to threaded end of pushrod.
Note:
Thread ball link half way onto pushrod to
allow for proper adjustment during final
installation.
8. Assemble brass threaded coupler to 4-40 ball
link. Assemble ball link and brass spacer to the
servo arm as shown below.
9. With servo arm still 90 degrees to servo and
throttle arm of carburetor in the center or half
throttle position. Mark the cut location for the
throttle push rod.
10. Remove pushrod from throttle arm on carburetor
and cut throttle pushrod to length.
11. Gather the soldering tools as shown below.
Note:
For best results we recommend a high
quality silver solder like “Sta-Brite” Silver
Solder.
