Aeroworks 30cc Freestyle Extra 260 Assembly Manual
25
9. Install the wheel pant using two 4-40 mounting
bolt, lock washers and flat washers. Use blue
Loctite on mounting bolt to ensure it does not
come loose from vibration.
Note:
Blind nuts have been preinstalled in wheel
pant.
10. Repeat above steps for other wheel and wheel
pant.
6. Check alignment of axle with cutout in wheel
pant. Check alignment of wheel pant mounting
holes with mounting holes in gear. Securely
tighten axel to gear strut.
7. Install inner wheel collar. Use blue Loctite on
the wheel collar set screw before final tighten-
ing.
8. Install 3” wheel and outer wheel collar. Use blue
Loctite on the wheel collar set screw before final
tightening
ENGINE INSTALLATION
1. The 30cc Freestyle Extra 260 will accept a wide
range of engine types. The DLE 30 engine with
J-Tec Pitts Muffler was used for the test flights.
Gather the following items needed for engine
installation:
Required Parts
◊
1 - Universal Mounting Template
Required Parts -Not Included
◊
1 - 30cc Engine: DLE 30 Shown
◊
4 - DLE 30 Standoffs w/ Mounting Bolts
◊
8 - 1/2” Diameter Fender Washers
◊
4 - 60mm Standoffs
Required Tools and Adhesives
◊
1 - Pencil
◊
1 - Masking Tape
◊
1 - Electric Drill
◊
1 - 3/16” Drill Bit
