ASR1200 Rotary Stage User's Manual
Installation
Chapter 2: Installation
This chapter describes the installation procedure for the ASR1200 stage, including handling the stage prop-
erly, preparing the mounting surface to accept the stage, securing the stage to the mounting surface, attach-
ing the payload, and making the electrical connections.
Installation must follow the instructions in this chapter. Failure to follow these instructions
could result in injury and damage to the equipment.
2.1. Unpacking and Handling the Stage
Carefully remove the stage from the protective shipping container. Use compressed nitrogen or clean, dry air
to remove any dust or debris that has collected during shipping.
If any damage has occurred during shipping,
report it immediately.
Before operating the stage, it is important to let the stage stabilize at room temperature for at least 12 hours.
Allowing the stage to stabilize to room temperature will ensure that all of the alignments, preloads, and tol-
erances are the same as they were when tested at Aerotech. Set the stage on a smooth, flat, and clean sur-
face.
Each stage has a label listing the system part number and serial number. These numbers contain information
necessary for maintaining or updating system hardware and software. Locate this label and record the infor-
mation for later reference.
Improper stage handling could adversely affect the stage’s performance. Use care when
moving the stage. Manually lifting or transporting the stage can result in injury
Do not allow the stage to drop onto any surface.
www.aerotech.com
Chapter 2
9
